phase 3 is over

Power module is already connected to LIPO via a new XT60 connector. I did replace also T-bean connector on drone frame and this means all copter connectors base on XT60 standard now.

I  made quick test to check if Pixhawk and Raspberry can be powered from modified power module. As a result I can say a new UBEC works fine and all 3 parts: RPI and Pixhawk and modem works very stable without any freeze.

This will allow me to detach my power bank from the frame when I will start to mount a new autopilot on copter frame. Phase 3 is over, one power source can power all copter parts.